s32k144evb.rs

Board support crate for NXP S32K144EVB evaluation board

Programming and debugging

OpenSDA

This boards uses OpenSDAv1 for programming and debuging

J-Link interface

J-Link supply firmware for OpenSDA hardware, with this you will be able to use the evaluation board as a J-Link programmer/debugger. For instructions how to do this look here, i've used this method with the OpenSDAv1 generic firmware supplied here

Bobbin-CLI

Bobbin-cli greatly simplifies compilation and flashing embedded software written in Rust. After installing the j-link tools, it can be installed by running cargo install bobbin-cli. Run the LED example on a connected evaluation board with j-link firmware (or an external j-link) with bobbin load --example led or check out the readme for a full description of what you can do.

Getting started coding (quickstart)

There exists a quickstart template for s32k144evb projects. You can find the documentation here

License

Licensed under either of

• Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)

• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)

at your option.

Contribution

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.